1, the plane will be reserved in the front rack, rack, rear frame installed in a predetermined position, and the level of calibration and firm ground contact, the center line of the frame in a vertical line; cannot be installed at the same time makes the frame offset, shake phenomenon, in order to avoid the accident.
2, the installation of the oven in order to each rack, and bolt fixed fixed; keep the oven and rack level, stability.
3, the power distribution cabinet installed in front of the rack or easy to operate, according to the instructions to connect the various circuits, and finally connected to the power supply (wiring must be disconnected from the power supply).
4, according to the set location to install each internal configuration, the dielectric and unwinding winding roll adjustment and horizontal, parallel axes perpendicular to the direction of movement of the tape. Not in the installation process to make smooth surface with different dielectric roll scratch, keep all the parts of the correct installation.
5, the gear, pulley, sprocket press installed, and try to rotate properly, to ensure flexible rotation, no exception, no blocking phenomenon, and to the chain, reducer and so on to add the corresponding lubricants.
6, check whether the installation is missing, to ensure that the heater thermal sensor, a transmission medium roll installation; check circuit is connected properly, the wires without leakage; the whole body is not offset, oven interval etc..
7, after the installation is correct, one by one boot test machine, if there is abnormal, should immediately stop checking adjustment; confirmed after completion of the boot production (during operation should pay attention to personal safety and machine safety).
Belt conveyor, automatic slitting machine